How To Test A Starter Solenoid Switch. Often this is done with the help of a multimeter to determine if the starter solenoid is working the right way. The starter solenoid on a riding lawn mower is essentially an electromagnetic switch.
The starter and solenoid are. If the engine starter motor turns over or runs then the starter ignition switch is faulty and requires replacement. You will need to locate the starter which is one large cylinder with a smaller cylinder attached to it.
Use the R1Resistance scale of the multimeter to measure the resistance of the pull-in coil and the holding coil of the solenoid and the resistance value shall be same with the starter solenoid specification.
3 ways to start your car with a bad starter. If the voltmeter reads 12-volts while in the ON position and no voltage in the OFF position the solenoid is not defective. Starter spins without fully engaging the flywheel rare engine cranks slowly rare test the battery. Use the R1Resistance scale of the multimeter to measure the resistance of the pull-in coil and the holding coil of the solenoid and the resistance value shall be same with the starter solenoid specification.
